poche ceinture zippée
Se ferme complètement, positionnée à hauteur de la taille pour un accès rapide en pleine marche.
3-layer pants for ski touring and mountaineering, waterproof to 20,000 mm and with side ventilation, made from recycled polyester woven in Ardèche and assembled in Poland.
Technical specifications
Windbreaker
Waterproofing
Water-repellent
Breathability
Activities
A skin track climb under the sun, a transition to the other slope, and the wind picking up again: when ski touring, pants need to do both, withstand snow on the descent and let heat escape on the climb. SUPA was built around this dual requirement.
The polyester membrane has a 20,000 mm hydrostatic head, and all seams are sealed with heat-taped seams to block the usual points of water ingress, especially at the knees and seat. The PFAS-free water-repellent treatment makes wet snow bead up before it can soak the fabric.
Two zippered side vents let you air out without taking off your gear, lower-leg zips make it easier to pull the pants on with your boots on, and the Velcro-opening gaiters close over your boots. The edge guards stand up to ski edges and crampons, while the zippered gusseted cargo pocket holds skins or a phone, secured by its mesh sleeve and safety loop. Hydrophobic YKK Aquaguard Coil 5 mm zippers throughout.
The garment in detail
Se ferme complètement, positionnée à hauteur de la taille pour un accès rapide en pleine marche.
Se ferme complètement, positionnée sur le côté de la cuisse pour un accès en pleine marche rapide.
Se ferment complètement, s'ouvrent pour évacuer la chaleur en montée sans jamais retirer la couche.
PERFORMANCES
Sympatex membrane, 20,000 mm, RET < 8, recycled polyester
Reinforced polyamide fabric edge protectors
Fit & support
Coupe Active Fit
SIZE GUIDE
Make your equipment last
Laver en machine à 30°C avec une lessive douce, éco de préférence, et sans excès.
Pas de javel : ni les fibres ni les couleurs n'y survivent, mieux vaut s'abstenir.
Sécher au sèche-linge à basse température, sans excès de chaleur pour ménager les fibres.
Ne pas nettoyer à sec : les solvants du pressing ne lui réussissent pas.
Fermer zips et boutons avant lavage, pour protéger la pièce et le reste de la machine.
Laver avec des couleurs similaires, pour éviter les mauvaises surprises au déballage.
Réactiver la déperlance avec un spray sans PFC après lavage, pour que l'eau reperle.
Ne pas repasser : cette matière n'apprécie pas du tout la chaleur du fer.
Complete your outfit