poche ceinture zippée
Se ferme complètement, positionnée à hauteur de la taille pour un accès rapide en pleine marche.
3-layer mountain pants for winter mountaineering, waterproof and breathable, water-repellent without PFAS, made from recycled polyester woven in Ardèche and assembled in Poland.
On a ridge route, you can go from the trail to shelter from the wind and then into wet snow within a few hours. SUPA is built for that pace, with a 3-layer construction that keeps you protected without having to stop every half hour to adjust anything.
The Sympatex membrane offers a 20,000 Schmerber rating and a RET of under 14, and all seams are sealed with heat-bonded tape. Hydrophobic YKK Aquaguard Coil 5 mm zippers complete the package, including on the pockets where water usually gets in first.
Two zippered hand-warmer pockets, a gusseted cargo pocket with a water-drain eyelet, a phone mesh pocket, and an interior safety attachment loop. At the bottom, the gaiters open with Velcro, the ankle zips make it easy to pull the pants on with boots on, and the crampon and ski-edge reinforcements stand up to knocks.
Se ferme complètement, positionnée à hauteur de la taille pour un accès rapide en pleine marche.
Se ferme complètement, positionnée sur le côté de la cuisse pour un accès en pleine marche rapide.
Se ferment complètement, s'ouvrent pour évacuer la chaleur en montée sans jamais retirer la couche.
Sympatex membrane, 20,000 mm, RET < 8, recycled polyester
Reinforced polyamide fabric edge protectors
Coupe Active Fit
SIZE GUIDE
Laver en machine à 30°C avec une lessive douce, éco de préférence, et sans excès.
Pas de javel : ni les fibres ni les couleurs n'y survivent, mieux vaut s'abstenir.
Sécher au sèche-linge à basse température, sans excès de chaleur pour ménager les fibres.
Ne pas nettoyer à sec : les solvants du pressing ne lui réussissent pas.
Fermer zips et boutons avant lavage, pour protéger la pièce et le reste de la machine.
Laver avec des couleurs similaires, pour éviter les mauvaises surprises au déballage.
Réactiver la déperlance avec un spray sans PFAS ajoutés intentionnellement après lavage, pour que l'eau reperle.
Ne pas repasser : cette matière n'apprécie pas du tout la chaleur du fer.