-
NewLAGOPEYE CAT4 sunglassesSold out -
Bien choisir ses vêtements de randonnée homme, couche par couche
Setting off from the parking lot at 7 a.m., 4 °C in the shade; at the pass, three hours later, the sun is warm and the wind is blowing. A good men's hiking garment can't handle these changes on its own: it's how the pieces are layered that makes the day. Ours can be taken off and put back on without a long break, and repaired if a zipper breaks.
L essentials
- First layer in recycled polyamide for exertion, or upcycled wool in cold weather.
- Second layer: microfleece or grid fleece while hiking, down jacket for breaks.
- Outer layer: 3-layer membrane jacket for rain, softshell or windbreaker in dry weather.
- Bottoms: 4-way stretch pants, shorts when the temperature rises.
- A 5-year commercial warranty, in addition to the 2-year legal warranty of conformity, and a repair service.
Men's hiking clothes, layer by layer
Every men's hiking garment in our range has a specific role in an outfit. Mixing them up comes at a cost in comfort: a thick fleece worn next to the skin on an uphill climb becomes soaked with sweat and leaves you chilled at the first stop. Here's how our pieces fit together.
The first layer: wick away sweat
It touches the skin and should wick moisture away from the fabric. The TEETREK uses 145 g/m² recycled ECONYL polyamide knit, knitted and dyed in Italy, then assembled in Lithuania, with mesh panels along the sides, where the backpack blocks airflow; it weighs 120 g in size M. The ROKA uses the same weight in a long-sleeved version, while the GANGA weighs 110 g/m² and has a hood that fits under a helmet. Both have a UPF 50+ rating, valid when the fabric is dry: protection decreases when the fabric is soaked. In cold weather, the TYTO takes over with 145 g/m² upcycled wool knit, sourced from deadstock in France, which retains its warmth even when damp.
The second layer: insulation without overheating
It's important to distinguish between a fleece you wear while hiking and one you put on when you stop. For active use, the SISKIN features 185 g/m² grid fabric made from recycled polyester: its grid traps warm air while letting moisture vapor escape, and its close-fitting hood fits under a helmet. The DOHLE, knitted in Italy and assembled in Portugal, and the JULEECE3, assembled in Hungary, are 220 and 240 g/m² half-zip microfleece tops that you can unzip on the way up. For breaks and early starts, the RYPA has 300 g/m² fabric and membrane panels on the shoulders. When the cold really sets in, the HEYDO2 down jacket, rated for comfort down to -20 °C and weighing 650 g, woven in France and assembled in Poland, waits at the bottom of your pack.
The outer layer: rain and wind
The EVE jacket is a 3-layer recycled polyester shell with a Sympatex membrane that withstands a 20,000 mm water column and has a RET rating below 8; sealed seams, a three-way adjustable helmet-compatible hood, 600 g, made in Poland. It's the one to pack whenever the weather looks uncertain. In dry weather, a softshell is more breathable: the UKPIK weighs 306 g in size M, while the internally brushed TENGMALM provides more warmth at 480 g. The NAGALAKA windbreaker weighs 180 g, is made from fabric woven in Isère, and packs into a backpack pocket. All these pieces are part of our men's technical jackets.
Bottoms: pants or shorts
The men's hiking pants PTARMIGAN2 and RIOUPOU share 175 g/m² 4-way stretch recycled polyamide fabric. The former adds 200 g/m² ripstop reinforcements on the seat, thighs, and knees for scrambling, and weighs 290 g; the latter is more understated and weighs just 282 g. As soon as temperatures rise, our men's hiking shorts use these same fabrics: PTARMIGAN2, RIOUPOU, PERNICE SH 2, or MILVUS with its integrated liner shorts. For snow, the softshell PTARMITOUR pants, brushed on the inside, go up to 240 g/m².
What should men wear hiking in each season?
The layering principle does not change throughout the year; only the thickness and where you carry the layers, on your back or in your pack, vary.
In summer
L’summer hiking outfit for men comes down to just a few pieces: a technical T-shirt, shorts or lightweight pants, a cap like the SOWA, and a warm layer and waterproof jacket in your pack for late-afternoon storms. At altitude, UV exposure remains high even when the air is cool: a long-sleeved UV-protective shirt like the ROKA or GANGA covers your arms more reliably than hastily applied sunscreen, keeping in mind that its protection decreases when the fabric is wet. Our article on technical clothing for summer hiking goes into more detail about this outfit.
In the shoulder seasons
In spring and fall, temperature swings within a single day are at their greatest. This is the season when men's hiking clothing is layered the most: a microfleece over a long-sleeved top, a softshell to block the wind, and a membrane jacket in reserve. The SWYPA sleeveless fleece, 300 g/m² and weighing 360 g, keeps your torso warm while leaving your arms free under your pack straps. A GEBO hat and a neck gaiter take up little space and make all the difference when you stop.
In winter
In winter, it’s better to add layers than look for one very warm garment. Here’s a typical outfit for a day on packed snow:
- Long-sleeved upcycled wool next to the skin.
- A grid fleece during exertion, with a down jacket put on at every stop.
- A 3-layer jacket or softshell depending on the weather, and brushed softshell pants if the snow is dry.
- A hat, gloves and neck gaiter in an accessible pocket.
Our three-layer system guide explains how to adjust each layer to your effort and altitude.
What our men's hiking clothing is made of
The fibers in our men's hiking clothing are recycled or upcycled: ECONYL regenerated polyamide made from fishing nets, textile scraps and used carpets, recycled polyester made from plastic bottles, and upcycled wool. L’assembly takes place in the European Union, and each product page specifies where: Lithuania for the TEETREK and the GANGA, Hungary for the UKPIK and the JULEECE3, SISKIN and RYPA fleece jackets, Portugal for the DOHLE, and Poland for the EVE and the HEYDO2. L’material origins are listed separately for each product, because a fabric may be knitted in Italy or woven in Spain before being assembled elsewhere.
Our clothing contains no PFAS, and hasn't since the brand was founded in 2018: our water-repellent treatments are formulated without fluorinated compounds. They fade with washing, and a care spray is all it takes to revive them. Every garment comes with a 5-year commercial warranty, in addition to the 2-year statutory warranty of conformity. A broken zip or open seam can be handled by our service team to have a Lagoped garment repaired rather than replaced.
Frequently asked questions about men's hiking clothes
What should you pack for a day hike?
A basic men's hiking clothing kit consists of four pieces, worn or packed away: a technical T-shirt, a lightweight fleece, a waterproof jacket, and stretch trousers or shorts. Add a cap and sunglasses in summer, and a beanie and gloves when the day looks cool at altitude. The key is being able to add or remove a layer in two minutes without emptying your pack. That keeps you from working up a sweat on the climb and then getting cold at the summit.
Waterproof jacket or softshell: which should you choose?
The two do different jobs. A membrane jacket like the EVE keeps out heavy rain, but is less breathable than a softshell when the slope gets steeper. A softshell like the UKPIK blocks the wind, handles a short shower thanks to its water-repellent finish, and lets moisture escape, but will eventually get soaked in prolonged rain. Our take: if you're only getting one, choose the membrane jacket; the softshell becomes the most-worn piece once you start hiking often in dry weather.
How do you care for men's hiking clothes?
Most of our technical garments can be machine-washed at 30 °C with a mild detergent, with the zips closed, then air-dried, preferably on a hanger; always follow the care label on each garment. When water no longer beads on a jacket or trousers, applying a fluorine-free water-repellent spray to the clean, still-damp garment after washing will restore the surface treatment. The membrane itself does not need to be retreated.
DISCOVER OUR STORIES AND ADVICE
Return to the Land of the Meije: Three Acts of Climbing and Mountaineering
How to Choose Your Beanie: The GEBO Guide
Heading to the mountains without a car: one year of Topo Doux with Florian Garibal