poche ceinture zippée
Se ferme complètement, positionnée à hauteur de la taille pour un accès rapide en pleine marche.
3-layer mountain pants for winter mountaineering, waterproof and breathable, water-repellent without PFAS, made from recycled polyester woven in Ardèche and assembled in Poland.
Technical specifications
Windbreaker
Waterproofing
Water-repellent
Breathability
Activities
On a ridge traverse, you go from the trail to shelter from the wind and then into wet snow within a few hours. SUPA was built for that pace, with a 3-layer construction that protects you without making you stop every half hour to adjust anything.
The Sympatex membrane has a 20,000 Schmerber rating and a RET below 14, and all seams are sealed with heat-bonded tape. Hydrophobic YKK Aquaguard Coil 5 mm zippers complete the design, including on the pockets where water usually gets in first.
Two zippered hand-warmer pockets, a gusseted cargo pocket with a water-drain eyelet, a phone mesh pocket, and a safety attachment loop inside. At the bottom, the gaiters open with Velcro, ankle zips make it easier to pull the pants on over your boots, and the edge guards stand up to crampon and ski-edge impacts.
The garment in detail
Se ferme complètement, positionnée à hauteur de la taille pour un accès rapide en pleine marche.
Se ferme complètement, positionnée sur le côté de la cuisse pour un accès en pleine marche rapide.
Se ferment complètement, s'ouvrent pour évacuer la chaleur en montée sans jamais retirer la couche.
PERFORMANCES
Sympatex membrane, 20,000 mm, RET < 8, recycled polyester
Reinforced polyamide fabric edge protectors
Fit & support
Coupe Active Fit
SIZE GUIDE
Make your equipment last
Laver en machine à 30°C avec une lessive douce, éco de préférence, et sans excès.
Pas de javel : ni les fibres ni les couleurs n'y survivent, mieux vaut s'abstenir.
Sécher au sèche-linge à basse température, sans excès de chaleur pour ménager les fibres.
Ne pas nettoyer à sec : les solvants du pressing ne lui réussissent pas.
Fermer zips et boutons avant lavage, pour protéger la pièce et le reste de la machine.
Laver avec des couleurs similaires, pour éviter les mauvaises surprises au déballage.
Réactiver la déperlance avec un spray sans PFC après lavage, pour que l'eau reperle.
Ne pas repasser : cette matière n'apprécie pas du tout la chaleur du fer.
Complete your outfit